Your carpets are prone to certain types of damage and
stains. Water may damage it. You may also have your leaks in your toilet or
probably your water heater is damaged or your faucets aren’t turned off and it
runs out from your sink for hours. All these situations can ruin and give
unnecessary stains on your carpets. So, what’re you going to do about it?
Carpets here in Melbourne, just like any other carpets
in general aren’t strong against certain damages. And in order for you to get
certain information with regards to cleaning them, you should know certain
myths and learn the truth about it.
Usually, residential carpets have a pad underneath it. This
pad can measure from ¼ of an inch to an inch in terms of thickness. The purpose
of this pad gives certain cushioning which makes you become more comfortable
and satisfied upon stepping on it. However, some carpets Melbourne in commercial use don’t have pad underneath.
Carpet pads are like sponges, they can absorb water easily.
That’s the problem. The pad under your carpet acts like a pod which means it
can hold water more times even more than its weight. Pads are designed to give
cushion to your feet which is spongy by nature. Of course, it will soak up
water like regular sponges in your kitchen.
Here’s another thing, although the carpet might feel very
solid underneath your feet but it’s not very resistant to water. It can easily
pass through it. Carpets are some sort of a sieve to water. A typical carpet
won’t hold more water for more than a few ounces per square foot of carpet
before it becomes saturated. After these waters have entered in the carpet, any
other further water filters will go straight through the carpet and directly to
the pad.
Water loves to travel; it doesn’t stay in one place. If it’s
given enough space, it will immediately flow. You must remember that wet will
go to dry. Water will always dry up as it meets a lot of other materials. Water
which is found at the centre of the room will always flow
through the carpet across the pad to the walls. It will then move on to the
edges of the room in just minutes or even hours depending on how much water was
spilled.
Upon touching the edge of the carpet, you might not feel it
being damp. However, the pad could be saturated. It can only be seen through an
infrared camera. This particular tool is very useful in finding the actual area
where water has caused damaged even through you can’t see or feel it.
All in all, preventing damage can be hard to do. No matter
how you try to protect your carpets, the chances of it being damaged are there.
What you can do is to have it maintained constantly. With the right people who
have the right tools, you can maintain the integrity and the beauty of your carpet.
You shouldn’t be afraid to replace your carpets; there are a lot of cheap carpet stores here in Melbourne. Find the right store and get
yourself a new one if needed.
0 comments: