How to Install Your Carpet Tiles?

CarpetMelbourneDirect.com.au

It is always a great idea to have some sort of carpeting in your home.  A nice carpet will help you keep your floors in good condition, especially in high-traffic areas like your living room.  It is also a great way to insulate the home and keep the floors from becoming too chilly, especially in places where the weather can drop drastically during the winter months.

However, while a traditional carpet can be very attractive, it can also be rather high-maintenance.  If you are a busy person who needs some sort of carpeting that is cheap and easy to clean, then carpet tiles are a better option for you.  Of course, another huge plus of choosing tiles rather than wall-to-wall carpets or rugs is the easy installation.  You can even put them in yourself.  Here is how to do it.

1.  Estimate the number of tiles that you need.  It is essential to find out how many carpet tiles you will need to cover the space in question.  Fortunately, carpet tiles come in uniform sizes, so with a little math it should be fairly easy to figure out how many that you need.  Most brands come in eighteen-by-eighteen inch squares, although you should probably check your dealer to see if they do, in fact, carry this size.
Either way, you should measure the room that you will be putting the tiles in.  Measure the length of the room and the width.  Multiply these two numbers to find your floor area.  Bring these measurements to the store and buy the tiles that you need.  Be sure to get more tiles than your estimate – it is better to have some leftover than to find you do not have enough.

2.  Clean the room.  Naturally, you will have to start with a nice, dust-free space.  Remove all the furniture in the room, including old carpets.  Vacuum thoroughly and wipe your floors down with a mop and some soapy water.  Finish with disinfectant and wait for it to dry. This way, you clean slate and you can be sure that it would be perfect.

3.  Put in the tiles.  Your tiles can be installed once you have a clean, dry floor.  Find the center of the room and start putting down your tiles there.  Make sure all the tiles are facing in the same direction so they will fit snugly and go down nice and flat.  When you get to the edges, you will most likely have some odd spaces or corners.  Cut the tiles to fit these spaces, keeping them aligned all the while.  Save any excess tiles in case you need to replace those have already installed.

The cutting may get a little tricky especially if it is your first time. What you must do is find the right tools for you to do the job perfectly. It would also be nice to try to cut scrap pieces first just for practice. Until you get the hang of it, then you can down the tile that you will be installing. How do I get carpet tiles in Melbourne?